Alternatively, the installed version of the device driver does not match that of the installed version of HP-UX. This example shows that a mpt function is called. Get the latest from: Kudos points for any replies Tagged commands queued for this initiator were cleared by another initiator.
|Date Added:||1 October 2006|
|File Size:||6.72 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
mptconfig – HP-UX
Controller reset has been successfully completed. Timeout called with negative time. I believe it does Thanks in advance and any response is appreciated.
Disk Inquiry Vendor ID Your version is quite old. Solution Use the following command to check which kernel function the messages are related too: Alternatively, the installed version of the device driver does not match that of the installed version of HP-UX.
The fix from JAGag on Check with following command which mpt driver is installed: Install the correct version of the driver. In this case the installed version of mpt driver is older than the one with the fix B.
HP-UX Ultra320 SCSI driver
There is a known issue like this for mpt scsiU driver older than B. Release notes for the mpt driver version B. Timeout called with negative time.
Click here to access the technical article at: The fix will be released with Fusion.
How to correct Ultra320 SCSI Bus Reset EMS errors
Yes, that was a very annoying bug in the driver. Install the latest MPT driver.
The mode parameters in effect for this initiator have been restored from non-volatile memory. Alternatively, the mode parameters, microcode, or inquiry data for the device have been changed. Alternatively, a removable medium has been loaded or replaced.
The mode parameters in effect for this initiator have been changed by another initiator. Thanks Bill, Yeah I know the firmware might want to be upgraded Version 11i v2 Revision B.
Offset to Logged Manager Information: The device has been reset by a Bus Device Reset message, a hard reset condition, or uux power-on reset. Tagged commands queued for this initiator were cleared by another initiator. The EMS error event message will appears several times.
Command Data Block Contents: It can be downloaded from software. I believe HP had resolved that prior to my version I guess I can check with them.